Build From Source on MacOS

Table of contents

  1. Prerequisites
  2. Configuration
  3. Build the code
  4. Installation
  5. Running tests


In order to compile PcapPlusPlus on Linux please make sure you have the following components installed:

  1. Xcode which contains all prerequisites required for PcapPlusPlus including gcc/g++ compiler and libpcap with all relevant header files
  2. Make sure you have Xcode Command Line Tools. You can install it by running the following command in Terminal:

     xcode-select --install
  3. OPTIONAL - install Zstd if you wish to enable PCAPNG streaming compression support:
     brew install zstd


Run the configuration script from PcapPlusPlus main directory:


This script has the following command-line switches (you can also view then by running ./ --help or ./ -h):

no switches use the default configuration
--use-immediate-mode use libpcap immediate mode which enables getting packets as fast as possible (supported on libpcap>=1.5)
--set-direction-enabled set direction for capturing incoming or outgoing packets (supported on libpcap>=0.9.1)
--install-dir set a custom installation directory. Default is /usr/local
--libpcap-include-dir libpcap header files directory. This parameter is optional and if omitted PcapPlusPlus will look for the header files in the default include paths
--libpcap-lib-dir libpcap pre compiled lib directory. This parameter is optional and if omitted PcapPlusPlus will look for the lib file in the default lib paths
--use-zstd use Zstd for PCAPNG streaming compression. This parameter is optional
-h, --help displays a help message and exits. No further actions are performed

Here are a few examples:

Default configuration:


Configure PcapPlusPlus with libpcap’s immediate mode:

./ --use-immediate-mode

Configure PcapPlusPlus with libpcap’s set direction:

./ --set-direction-enabled

Provide non-standard paths for libpcap header and library files:

./ --libpcap-include-dir /home/myuser/my-libpcap/include --libpcap-lib-dir /home/myuser/my-libpcap/lib

Provide a custom installation directory:

./ --install-dir /home/myuser/my-install-dir

Use Zstd for pcapng compression:

./ --use-zstd

Build the code

After running the config script, you’re can safely build the code:

  1. Run make or make all from PcapPlusPlus main directory
  2. This should compile all libraries, unit-tests and examples
  3. To build the libraries only (without the unit-tests and examples) run make libs instead of make all
  4. After compilation you can find the libraries, examples, header files and helpful makefiles under the Dist directory


After build is complete you can run the installation script which will copy the library and header files to the installation directory:

MyMAC:PcapPlusPlus seladb$ sudo make install
Installation complete!
MyMAC:PcapPlusPlus seladb$

The default installation directory is /usr/local which means the header files will be copied to /usr/local/include/pcapplusplus and the library files will be copied to /usr/local/lib.

You can change the installation directory by using the --install-dir switch in the configuration script.

Running tests

PcapPlusPlus contains a set of test-cases you can run to make sure that everything works correctly on your system. This guide contains detailed instructions on how to run them.